AREAS OF EXPERTIES
Our Office Direction

COMMERCIAL/RETAIL


Vario Systems, Office Building, Southlake, TX.
Structural design for a two-story, 65,000-square foot structure. The structural system consists of open web steel joist for roof and floor system enclosed with concrete tilt-up panel. The foundation system consists of under reamed concrete piers and slab-on-grade foundation system. Design


McDermott Square, Plano, TX. Structural design for the first building of a six-building master planned, multi-use site. The building 1 is 35,000 square feet of shell retail shopping center. Design


Teel Village, Frisco, TX. Structural design for the first building of an 11-building, multi-use site. The overall site encompasses 25,200 square feet of shell retail shopping center. Design


Lake Shore Crossing, Little Elm, TX. Structural design for a one-story shopping center, a commercial multi-use space of approximately 35,000 square feet on a master planned site. 2CMD was responsible for structural design of the shopping center shell building. Design





LCA Rental, Haltom City, TX. A/E design for an 8,750-square foot pre-engineered office/warehouse building. The project consists of a warehouse whose roof is a single-span of 70 feet by 130 feet, with an average eave height of 19-feet, and a 1,200-square foot, two-story office space. The exterior of the building is split face block veneer. 2CMD’s duties included design and construction management for this $500,000 design-build project. Design-Build


Furniture Market Phase I & II, Grand Prairie, TX. 2CMD was a CM-at-Risk, design-build project for the development of a 5.5-acre property to construct an 18,000 & 32,000-square foot furniture store. Duties included the design and development of agricultural land to commercial property, addressing drainage concerns, landscaping, utilities and vertical construction of the retail structure. CM


CentrePort IV, American Airlines, Fort Worth, TX. Performed “fast-track” structural design for a sixstory speculative office building. The structural system consisted of a concrete skip pan joist floor system supported by a concrete beam and column frame system founded on a concrete beam and pier foundation system.* Design


Goodwill Building, Fort Worth, TX. Structural design for a one-story, 35,000-square foot administration building. The structural system consists of a metal deck on open web steel bar joists, supported by steel wide-flange beams and columns. The foundation system is floating 5- inch slab-on-grade over engineering fill subgrade, with perimeter grade beam and drilled caissons under roof columns. The wall system consists of light-gauge metal studs and a stucco finish. * Design

 

 

 
DFWMBC HUB SCTRCA NCTRCA SBA_8A TxDot